Adventurer3を制御するためのもろもろ調査したもののまとめ
3D PrinterAdventurer3 Control – 3
Survey result of G code command used in interaction with FlashPrint of Adventurer3.
Adventurer3 ControlAdventurer3 Control – 6.10
The Adventurer3 controller also supports the problematic part of Adventurer3-Wi-Fi connection with firmware Ver1.3.1.. ...
Adventurer3 ControlAdventurer3-Wi-Fi connection with firmware Ver1.3.1.
When I made Adventurer3 the latest farm, I found that FlashPrint Ver4.6 could not connect to the device, so I did a litt...
Adventurer3 ControlAdventurer3 Control – 6.9
Changed the method of searching the IP address of Adventurer3. Previously, it used a private MAC address. After fixi...
Adventurer3 ControlAdventurer3 Control – 6.8
It's been a while since Adventurer3 Control – 6.7, but new functions have been added. In addition, the source of the pr...
Adventurer3 ControlAdventurer3 Control – 7.2
I implemented monitoring of Adventurer3 with Raspberry Pi's Web server.
Adventurer3 ControlAdventurer3 Control – 7
I would like to consider if Adventurer3 can be controlled from an external smartphone.
Adventurer3 ControlAdventurer3 Control – 6.5
Added convenient commands for inserting and removing filaments and cleaning the nozzle. This completes as a control program for Adventurer3.
Adventurer3 ControlAdventurer3 Control – 6.4
The problem that bed temperature does not go up when using what was output by FlashPrint.
Adventurer3 ControlAdventurer3 Control – 6.3
We fixed about 4 bugs.